Submit search
3.5" flange ID, 12" x 5 3/8" OD, 6" tall, with sensor hole. This filter was also used on the original TRIC intake system and Venom system. Measure your flange i.d. before ordering. No returns on filters.As this filter is for an obsolete system, only a few remain in stock. Once they are gone, they are gone for good!
This is our PROPRIETARY dry nano media filter made exclusively for Halltech by Attack Blue. It fits all C7 Halltech Stinger intake systems
Blu-Bee Replacement Filter 4.5" flange. This is our CURRENT Blu-Bee dry nano media filter made exclusively for Halltech by Attack Blue. It fits the Killer Bee MF103/MF108/CF102/CF112 intake systems, the Killer Bee II, C5 Venom II and C6 Venom II. It will not fit the 1st Gen Killer Bee, which had a smaller 4" inlet (unless you add the 4.5-4.0" bushing reducer shown in the last two photos). No returns on filters. This filter has filtered air for a 9.97 @ 137.74 mph 1/4 mile run on a bolt on only Z06, a 9.97 139 mph run on a cam and heads Z06, and a 10.67 129mph run on a C6 base LS3 with bolt ons and cam only. It will flow enough air for any n/a application to 1000 HP.
Hornet replacement filter. This is our PROPRIETARY dry nano media filter made exclusively for Halltech by Attack Blue. It fits the Halltech C8 Hornet intake system. No returns on filters. This filter will not fit other C8 systems, of this we are sure. This 10"x16" obround filter has a huge filtered area of over 600 square inches (the stock C8 filter actually fits inside our filter).
Back to top